Catalog Course Search Details

 Department:    MT

 Course #:    270

 Credits:    5

 Variable:     No

 IUs:    5.5

 CIP:    470616

 EPC:    736

 REV:    2019

 Course Description  

Installation, design, and troubleshooting of hydraulic systems found on recreational and commercial vessels. These systems are used for stabilization, davits, lifting cranes, steering, and accessory drive equipment.

 Prerequisite  

Prerequisite: MT 132.

Contact Hours (based on 11 week quarter)

Lecture: 44

Lab: 22

Other: 0

Systems: 0

Clinical: 0

Intent: Distribution Requirement(s) Status:  

Vocational Preparatory Required for ATA degree  

Equivalencies At Other Institutions

Learning Outcomes

After completing this course, the student will be able to:

1. Understand design, scope and operation of marine hydraulic systems.
2. Understand the types, design, and operation of marine hydraulics controls.
3. Perform marine hydraulic system monitoring and troubleshooting.
4. Use a digital volt/ohm/amp meter to test control circuits including supplied voltage, voltage drop, continuity of a wire run, operation of a switch, fuse, electric valve or electric clutch.
5. Understand and install typical equipment for marine hydraulics systems, i.e. pumps, gauges, clutches, and controls.
6. Design and size a modern hydraulic system.
7. Install of electrical and manual control systems related to marine hydraulics.
8. Measure conditions of electrical system operation using a volt meter.
9. Understand typical installations and best practices in the marine industry.
10. Perform routine maintenance procedures on marine hydraulic systems.

General Education Learning Values & Outcomes

Revised August 2008 and affects outlines for 2008 year 1 and later.

Course Contents

1. Introduction to fluid dynamics and theory of operation.
2. Proper use of guidelines and recommended practices of the American Boat and Yacht Council and National Fire Protection Association relating to this content.
3. Installation of electrical and manual control systems related to marine hydraulics.
4. Familiarization with hydraulic equipment found on modern cruising vessels.
5. Electrical system operation using a volt meter.
6. Typical equipment for these systems: pumps, gauges, clutches, and controls.
7. Hydraulic system monitoring and troubleshooting.
8. Routine maintenance procedures on marine hydraulic systems.