Catalog Course Search Details

 Department:    MT

 Course #:    160

 Credits:    7

 Variable:     No

 IUs:    8

 CIP:    n/a

 EPC:    n/a

 REV:    2019

 Course Description  

Operation, service, troubleshooting and general maintenance of inboard gas and diesel engines in recreational and small commercial vessels. Tune-up procedures for gas ignition systems. Routine service and maintenance of these systems. Includes starting, charging, fuel, cooling, lubrication and winterization of engines.

 Prerequisite  

None

Contact Hours (based on 11 week quarter)

Lecture: 55

Lab: 44

Other: 0

Systems: 0

Clinical: 0

Intent: Distribution Requirement(s) Status:  

Vocational Preparatory Required for ATA degree, Required for certificate  

Equivalencies At Other Institutions

Learning Outcomes

After completing this course, the student will be able to:

1. Test the starting battery using common shop equipment.
2. Test starter motor operation both on and off the engine.
3. Diagnose and repair common starting problems of marine engines.
4. Perform preventative maintenance on the fuel system including injector, lift pumps, and system bleeding procedures.
5. Perform mechanical preventative maintenance on the cooling system.
6. Perform winterization tasks, commissioning tasks and 100 hour services of common marine diesel engines.
7. Demonstrate understanding of the operation of the marine engine by passing the final exam with a competency of at least 70%.
8. Perform basic electrical system testing of starting and charging systems.
9. Perform typical tune-up procedures on conventional breaker point ignition systems including removing and replacing spark plugs, points, condenser, and ignition wires.
10. Perform ignition timing checks and adjustments using timing light and tachometer.
11. Perform distributor advance testing using off the engine techniques, including static timing installation of distributor.
12. Test fuel pump delivery pressure.
13. Adjust carburetor fuel/air ratio mixture adjustments on a running engine.
14. Remove, disassemble, clean and rebuild typical marine carburetors.
15. Diagnose cooling system problems by flow testing and temperature measuring methods.
16. Perform lubrication system service.
17. PROGRAM OUTCOME: Demonstrate Mechanic & Electrical Skills.
18. PROGRAM OUTCOME: Develop knowledge & profiency to pass certification exams.

General Education Learning Values & Outcomes

Revised August 2008 and affects outlines for 2008 year 1 and later.

Course Contents

1. Starting system theory of operation, component testing of battery, wires, cables, solenoids, starter motors.
2. Charging system theory of operation, component testing of alternators and voltage regulator.
3. Fuel system operation, component testing of supply lines and valves, lift pump, filters, injector pump, fuel injector.
4. Injector service operations including pop-testing and adjustment of injectors.
5. Cooling system service for raw water and fresh water cooled engines.
6. Lubrication system service for marine diesel engines.
7. Valve adjustment procedures for typical diesel engines.
8. Batteries, battery switches, wiring for starting and engine monitoring gauges.
9. Ignition system operation and repairs for breaker point type, and capacitive discharge ignitions.
10. Fuel system service including fuel pump, filters and carburetor service and adjustments.
11. Complete engine tune-up procedures, including winterization activities.